Introduction to Shearing Machine Safety Matters

Precautions for safe operation of shears are as follows:

1. The shearing machine must be managed by a special person.

2. Dress code, wear tight-fitting protective clothing before operation, fasten the cuffs, and do not open the hem of the jacket. Do not wear, take off your clothes, or wrap your body around the machine to prevent the machine from being twisted. Safety helmets must be worn, braids should be put in the cap, no skirts or slippers are allowed.

3. The operator of this machine tool must be familiar with the main structure, performance and use method of the shearing machine.

4. This machine tool is suitable for cutting various steel plates, copper plates, aluminum plates and non-metallic material plates whose material thickness is the rated value of the machine tool, and must be materials free of hard marks, welding slag, slag inclusions, and welds, and excessive thickness is not allowed.

5. How to use this machine tool: (Guide: An automatic riveting processing method for stamping parts)

a. Adjust the gap of the blade according to the thickness of the material to be cut.

b. Adjust the profiling or fixture according to the width of the material to be cut.

C. Make 1,3 idle strokes before the machine is operated, and then cut work can be carried out after normal.

6. If the machine is found to be operating abnormally during use, immediately cut off the power supply and stop for inspection.

7. When adjusting the machine tool, you must cut off the power supply, and pay attention to the safety of your hands when moving the workpiece.

8. All parts of the machine tool should be kept lubricated frequently. The operator should fill the lubricating oil once every shift, and the mechanics should fill the rolling bearing part with lubricant once every six months.

9. During operation, the hands and feet should be coordinated. It is strictly forbidden to wear gloves, and it is strictly forbidden to reach into the pressure plate and knife edge.

10. For multi-person collaborative operations, a special person must be assigned to command. It is strictly forbidden to cut two pieces of material on the same shearing machine at the same time.

11. On-site cleaning work, it is forbidden to pile up workpieces and sundries in the workplace, so as to keep the machine tool and site clean at all times.

12. After finishing the work, cut off the power supply and lock the power supply box.

More related press and shearing machine industry news: