Introduction to some problems encountered in the processing of U-shaped stamping parts

Stamping parts processing plant, processing automobile and motorcycle parts, stainless steel stamping parts, special-shaped parts, in the process of automotive stamping parts processing, the bending rebound of U-shaped stamping parts is the key content of the bending process research; 1. U-shaped stamping parts are then bent The law Since the flat plate of the stamping part has been bent into a U-shaped part, compared with the same material thickness, the rebound angle is reduced and the fillet radius of the punch increases. How much is the fillet radius of the punch? After analyzing various data, it is found that the bending law of U-shaped stamping parts is related to the following factors; 1. The mechanical properties of the material and the rebound angle of the material are proportional to the yield point of the material and inversely proportional to the elastic modulus. 2. Relative bending The radius r/t is the bending radius of the workpiece along the length direction, and t is the height of the U-shaped part. The smaller the r/t value, the greater the deformation of the rounded area. When other conditions are the same, the springback angle varies with Increase with the increase of r/t; Second, U-shaped bending stamping parts have less springback than V-shaped parts, the shape of the workpiece is complex, each part is more involved, and the springback is more difficult; Third, in terms of mold design, U The greater the gap between the convex and concave molds of the bending mold, the greater the springback of the parts after unloading. Because of the excessive mold gap, the degree of bonding between the material and the mold is reduced, and the radial constraint on the straight edge of the bending part is also reduced. In this way, under the same other conditions, the larger the gap, the smaller the plastic deformation of the bending part, and the greater the springback of the part after unloading. For U-shaped bending stampings, the springback varies with The opening depth of the concave die increases and decreases, and the smaller the die gap, the smaller the amount of springback; article recommendation: What hardness tester should be used for different metal stamping parts materials Previous: Different metal stamping parts materials What kind of hardness tester should be used for testing