Introduction to the essentials of non-hazardous design of precision stamping dies [hardware]

The mold is an important process equipment indispensable for the manufacture of precision stamping parts. Its design structure is related to the accuracy and quality of precision stamping parts. Its production process is complicated and cumbersome. In addition to considering its performance, it must also consider its non-hazardous design. design. Now Panda will introduce you the key points of the non-hazardous design of precision stamping dies. 1. The structure of the precision stamping die should be as convenient as possible to ensure the convenience of feeding, ordering, discharging, and cleaning up waste. 2. The mold design should indicate the mold weight on the general drawing for easy installation and no danger. 3. Lifting and handling measures should be adopted for the processing of parts over 20 kg to avoid excessive labor intensity. 4. For the processing of small precision stamping parts, it is strictly forbidden for the operator's fingers, wrists or other parts of the body to extend into the mold area. 5. For the processing of large precision stamping parts, if the operator must manually enter the mold to work, the scope of the mold should be reduced as much as possible, the time that a part of the body stays in the mold should be shortened as much as possible, and the danger zone of the mold should be clarified. , Equipped with necessary protective measures and devices. 6. When assembling and disassembling mold parts, it should be convenient and non-hazardous. It is necessary to avoid the possibility of burrs, cuts or pinching of precision stamping parts, and the mold should be easy to disassemble and store. 7. It is not allowed to produce waste or workpiece missiles in the process of processing precision stamping parts, which will affect the attention of the operator or even hurt the operator. 8. The various parts on the mold should have sufficient strength and rigidity to prevent damage and deformation during use. The fastening parts should have anti-loose measures to avoid hurting people. In the process of precision stamping die processing, subtle problems can cause danger. Therefore, in the design and processing process, these problems should be considered in many aspects, and the operation should be standardized to ensure that it is not dangerous and feasible. If you want to know more about precision stamping parts, or have needs in this area, you can add V: understand.