Introduction to the safety design points of precision stamping dies

1. The structure of the precision stamping die should try to ensure the convenience of feeding, ordering, discharging, and cleaning up waste. 2. The mold design should indicate the mold weight on the general drawing to facilitate installation and ensure safety. 3. Lifting and handling measures should be adopted for the processing of parts over 20 kg to avoid excessive labor intensity. 4. For the processing of small precision stamping parts, it is strictly forbidden for the operator's fingers, wrists or other parts of the body to extend into the mold area. 5. For the processing of large precision stamping parts, if the operator must manually enter the mold to work, the scope of the mold should be reduced as much as possible, and the time that a certain part of the body stays in the mold should be as short as possible, and the danger zone of the mold should be clearly defined. , Equipped with necessary protective measures and devices. 6. It should be convenient and safe when assembling and disassembling mold parts, and avoid the possibility of burr cuts or pinching of precision stamping parts. The mold should be easy to disassemble and store. 7. It is not allowed to produce waste or workpiece missiles in the process of processing precision stamping parts, which will affect the attention of the operator or even injure the operator. 8. The various parts on the mold should have sufficient strength and rigidity to prevent damage and deformation during use. The fastening parts should have anti-loose measures to avoid hurting people. In the process of precision stamping die processing, subtle issues will affect safety, so in the design and processing process, these issues must be fully considered, standardized operations, to ensure safety and feasibility. Article source: product/.