Jiangmen metal stamping parts factory, what is the reason for the wrinkling of stamping parts + 3 million punching next-day production capacity manufacturers

The hardware production technician in charge of Jiangmen Hardware Stamping Parts Factory said that there are several factors that affect the wrinkling of stamping parts. Through specific practice, Xiaoshuo of Hardware has summarized the following reasons for everyone, and let everyone understand: (1) The drawing depth affects the distribution of material flow resistance along the cavity of the cavity and has a direct relationship with the drawing depth. In the concave and convex curve positions, excessive stretching depth can cause uneven distribution of deformation resistance and form wrinkles, which should be avoided as much as possible. (2) Adjust the size of the blank holder force. When wrinkles are evenly produced around the workpiece, it should be judged as insufficient pressing force. Gradually increase the pressing force to eliminate the wrinkles. When the tapered and hemispherical pieces are stretched, most of the material is suspended when the stretch starts. It is easy to cause side wall wrinkles, so in addition to increasing the blank holder force, it is necessary to increase the picking and stretching ribs to increase the radial tensile stress in the plate and eliminate the wrinkles. (3) The influence of the radius of the die fillet If the fillet radius of the die is too large, the roughness flows into the die and passes through the die fillet, the smaller the bending resistance to bending deformation. The smaller the bending resistance, the more likely it is to cause wrinkles. The smaller the radius of the die, the greater the bending resistance of the bending deformation, the less likely it is to wrinkle, but it is easy to cause cracking and napping of the part. Accumulation of a large number of production practices has proved that the main cause of wrinkling of stamping parts is the accumulation of materials during the stretching process and the excessive speed of local material movement. When formulating the actual solution, the corresponding mechanism of the mold should be adjusted from the above aspects, and good results will be achieved. Hardware, 15 years of focus on Jiangmen hardware stamping parts factory, 20,000+ sets of customized stamping die production experience, monthly processing capacity of 100+ sets of molds, hundreds of precision processing production equipment, daily production capacity of 3 million punches, silk-like stamping accuracy 0.01mm, the raw materials are imported and the original national standard factory, and 16 quality inspections are strictly controlled. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose to rest assured!