Making stamping parts is the process of stamping molds

Before making stamping parts, it is necessary to set up the stamping die to provide a stable and good foundation for the subsequent stamping process. So we need to understand how the stamping part manufacturer completes the stamping die set-up and what are the specific steps. ? For the stamping die used in the production of stamping parts, before setting the die, select a punch that is suitable for the tonnage of the die, and check whether the height of the die is within the allowable range of the punch. ; At the same time, clean up the lower table of the punch, and no foreign matter. There should be no debris on the bottom of the lower die seat of the mold, and it must be laid flat. Immediately afterwards, the stamping die for forming the stamping parts can be placed in the middle of the punching table, and at the same time, the stroke of the punching press can be selected for inching. When starting to set up the mold, you must first raise the slider, and then slowly drop to the bottom dead center by inching. For some molds with a mold handle, the mold handle must be aligned with the mold handle hole until the bottom dead center is closed, and the lower mold must be closed first. And some stamping dies do not have a die handle, so you only need to place the die in a suitable position, and pay attention to the die with a blanking hole not to block the blanking hole. It should be noted that the cushion used must be flat, and the force must be checked for balance, and be careful not to block the material to prevent blockage from damaging the mold. When setting up the mold of the stamping part, first shrink the upper mold for the formable mold, and then put in the waste of the required thickness of the punching material, use the slider to adjust to the appropriate closing height, and empty the punch two to three times, Tighten the lower mold. In the V-shaped mold frame, the upper and lower mold sliders are closed and clamped, and the slider is raised to the size of the punching thickness. It's not over yet, then check whether the upper and lower molds of the stamping parts are locked; whether there is any abnormality; put the tools in place, clean the site, and start the production of stamping parts after meeting the requirements.