Metal stamping die mold base on the group

In detail in order to shorten the processing cycle of metal stamping die, to strengthen the unity of the mould precision, operation personnel, reduce mold production will produce abnormal, to ensure the production quality and the die life. Metal stamping die mold base on group made in the following ten step step to complete: 1, plywood & Phi; 12. 000 location hole and vice guide pin hole circumference R1. 0 and 2, box with 600 # oil stone or polishing diamond knife bravely and remove burrs. 3, both sides templates to use 600 # and 1000 # oil stone bulldozed, remove the spring. 4, kerosene and alcohol will surface and inner hole clean. 5, assistant director suit with the template. 6, clamping part will punch into the template box, check whether the punch take put smooth. ( Punch and don't put in, in order to avoid accidentally touch off small punch) 7, to fix the punch with press. ( Note holder can't get too close to punch, so as not to interfere with the punch. ) Punch after fixed should have small space, to facilitate the punch guide is naturally. 8, will take off the board together with the back off gently into the plywood, check to take off the back of the plate must have without interference, completely and trendy, take off the backboard and plywood should be no gap between. After 9, into the blanking punch should exceed the pressure is zero. 8毫米( Less material thickness) The above. 10, into the adjustment screw and upper die, rotating screw until rushed closer to the effective height adjustment.