Metal stamping parts manufacturing-hardware

Metal stamping parts manufacturing should pay attention to the hardware tells you 1. Semi-automatic and manual punching machines must be equipped with a two-hand brake switch, and it is strictly forbidden to press with a pedal or one-hand start switch. 2. After the high-speed punching machine is adjusted, close the soundproof box after normal punching. 3. During continuous punching, employees cannot take the product by hand within 1M of the punching machine. 4. When the technician is on the mold and adjust the machine, only one person can debug, not two people. 5. The technician can adjust the machine and feed the material, only outside the machine, and the distance is not less than 1M. 6. The screws must be tightened when setting up the mold, and the machine must be shut down for 4 hours to check whether the screws are loose. 7. When there is a problem with the mold during the production process, there is no need to remove the mold. A sign that is under maintenance is hung on the power supply box before the mold can be repaired. 8. All tools are returned to the toolbox after use, and cannot be placed on the machine table to prevent the tools from slipping and hurting people. 9. When the machine is not in production, cut off the power supply in time. 10. For short and small workpieces, use special tools and not directly feed or pick up parts by hand. 11. The producer must stand properly, keep a certain distance between his hands and head and the punch, and always pay attention to the punch action, and chat with others is strictly prohibited. 12. Operators and mold repairers are strictly prohibited from reaching into the mold during production. 13. When installing the suction fan, the operator is strictly forbidden to reach out to the motor to clean up waste. If you want to know more, please consult or call the same number