Metal stamping parts processing customization, what is the reason for the waste during stamping + 3 million punching next day production capacity

What is the reason for the stamping waste produced during the processing and customization of metal stamping parts? The following hardware Xiaoshuo will analyze the causes and solutions according to the specific practical situation: 　　1) Reason: 　　The quality of the raw materials is poor; the die is installed and adjusted improperly; the operator does not feed the strip correctly along the positioning Or there is no guarantee that the strips are fed according to a certain gap; due to long-term use, the gap changes or the working parts and guide parts of the die are worn out; due to the impact and vibration for too long, the loosening of the fastening parts causes relative changes in the installation positions of the die; The negligence of the author and failure to follow the operating procedures. 2) Countermeasures: 　　The raw materials must conform to the specified technical conditions (strictly check the specifications and grades of the raw materials, and conduct laboratory inspections on the workpieces with high dimensional accuracy and surface quality requirements under conditions.); as specified in the process regulations All aspects of the process should be strictly observed; the presses and die and other tooling equipment used should be guaranteed to work in normal working conditions; a strict inspection system must be established during the production process, and the first stamping parts must be fully integrated Inspection, production can only be put into production after the inspection is qualified, and at the same time, the inspection should be strengthened, and the accident should be dealt with in time;> The cutting-edge numerical control technology WeChat is good, remember to pay attention. Adhere to a civilized production system, such as the transfer of workpieces and blanks, must use appropriate workstations, otherwise the surface of the workpiece will be crushed and scratched, which will affect the surface quality of the workpiece; ensure that the mold cavity is clean and work during the stamping process. Workpieces that need to be organized and processed in an orderly manner should be placed neatly. Hardware, 15 years of focus on hardware stamping parts processing customization, 20,000+ sets of stamping die customization production experience, monthly 100+ sets of mold processing capacity, hundreds of precision processing production equipment, daily production capacity of 3 million punches, silk-like stamping accuracy 0.01mm, the raw materials are imported and the original national standard factory, and 16 quality inspections are strictly controlled. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose to rest assured!