Metal stamping parts, solve the burrs and provide more processed and qualified stamping parts [hardware]

Metal stamping parts, in the production process of the workshop, often due to mold and operation problems, the stamping parts have burrs. Solving the problem of burrs is a prerequisite for providing qualified products to customers. The following Xiaoshuo will share a few points for you: To solve the burr, literally, it is to deal with the burr edge, which is actually defined as the processing technology of the burr produced by the inverted punching. The process feature is to process the metal stamping parts according to the method shown in the figure, and chamfer the edges of the burr surface into a right angle or a rounded corner, so as to achieve the effect of the burr edge being processed. This effect is similar to the deburring process, but the effect and efficiency are far higher than that of deburring. Hardware, 15 years of ingenuity focusing on metal stamping parts, 20,000+ sets of mold customization processing and production experience, daily production capacity of 3 million punching times, stamping parts accuracy up to 0.01MM, 16 quality inspections strictly for quality control. It can quickly solve time-critical problems for you, solve the accuracy problems of stamping parts, and solve the quality problems of mass production.