Operation specification of automatic lathe during stamping

When stamping parts manufacturers carry out stamping processing, the lathe operation needs to strictly follow the lathe operation specifications. Only in the case of observing the operating specifications of the lathe can it be guaranteed that there will be no production accidents, and the mass production efficiency of stamping parts is also higher. Operating specifications of automatic lathes: 1. It is not allowed to brake the spindle rotation by turning on the reverse. 2. When aligning the stamping parts, only use the hand to move the chuck or open the low-speed gear for alignment, and high-speed alignment is prohibited. 3. The installation of the CNC blade is not suitable for extending too long, the gasket should be flat, and the total width is consistent with the total width of the bottom edge of the CNC blade. 4. When loading and unloading the chuck, only forcefully rotate the V-belt to push the spindle to rotate, and do not immediately start the CNC lathe to force it to loosen or tighten it. In addition, it is necessary to block wooden boards in the protective layer on the surface of the lathe to avoid accidents. 5. When changing the rotation direction of the main shaft, stop the main shaft first and then start. It is forbidden to change the rotation direction suddenly. [Related recommendation] Learn more: What are the methods for polishing the surface of stainless steel? Learn more: Manufacturing characteristics of automobile stamping parts molds Learn more: Points to note in the design of continuous stamping dies (2)