Pitch positioning analysis of continuous stamping die in stamping factory-hardware

When the stamping processing plant designs the continuous stamping die, it will process the pitch positioning in the die. Why is pitch positioning only used for continuous molds, but pitch positioning is generally not used for engineering molds? That's because the general engineering molds are made of blanks, the size, length and width of the blanks are the same, so they can be directly placed in the engineering mold, otherwise they would not be called 'engineering molds'; of course, there are also engineering molds. For automatic feeding, usually the feeder is set up, and when the punch is hit, the feeder will automatically send the material. Continuous molds usually have special automatic feeders, otherwise how to make them? Manual feeding Because sometimes the feeding is inaccurate, the product scrap rate is too high, and the automatic feeding machine can avoid this risk. Moreover, only small factories use manual feeding, and larger factories have automatic feeding machines. Manually only need to place the materials on the automatic feeder as required, and then set it up. However, the automatic feeder may not be so accurate, and sometimes there will be small errors. At this time, the pitch positioning plays a very important role. Some people say 'Pitch positioning: the distance between two positioning pins.' Think about it, right? In fact, this statement is not wrong, in theory it is like this. But what is the distance between the two positioning pins? How is it calculated? Learning is endless, hardware, and a stamping factory with 15 years of experience. If you have more technical or production problems, you are welcome to communicate with Xiaoshuo at any time!