Precautions for dismounting the hardware shrapnel mold

1. Before pulling the mold, make sure that the metal shrapnel has been loosened and removed from the mold feed inlet. 2. When the mold cannot be pulled, one person can pull it out and one person can push it back. (Do not push back at the same time and push the mold out of the punching platform) You can also use the mold lifting screw to turn the screw hole of the lower mold base, and then lift it up with both hands at the same time and pull it out. 3. When the mold is pulled away from the punch, the mold trolley should not be turned too fast to prevent the guide plate or material pallet from hanging on the punch or the soundproof cover of the punch, causing damage to the mold parts or the mold slipping. 4. When the mold is abnormally lowered, it is not allowed to inching operation, especially after the mold stopper is plastic. 5. Turn off the punch host and other power supplies after the mold is lowered to avoid waste of resources. 6. When the mold is normally shut down, the mold needs to be operated until the guide pin enters the round hole of the material belt. (Prevent the material from retreating caused by the feeder not clamping the material when there is no air pressure. point. (It is easy to reduce the service life of the in-mold spring) Benefit is the building, and safety is the cornerstone. Dongguan Heju Precision Hardware Electronics Co., Ltd. has focused on the development and production of metal shrapnel molds and other types of molds for several years. It regularly educates its employees on safety matters, and has always put safety production in the first place, and declares the protection of customers’ property Lead to the hearts of every employee.