Precautions for dismounting the metal bullet mold

Hardware shrapnel Precautions for dismounting the mold: 1. Before pulling the mold, make sure that the pallet of the mold feed inlet has been loosened and taken off. 2. When the mold cannot be pulled, one person can pull it out and one person can push it back. (Do not push back at the same time and push the mold out of the punching platform) You can also use the mold lifting screw to turn the screw hole of the lower mold base, and then lift it up a little with both hands and pull it out. 3. When the mold is pulled away from the punch, the mold cart should not be turned too fast to prevent the guide plate or the material pallet from hanging on the punch or the soundproof cover of the punch, causing damage to the mold parts or the mold slipping off. 4. When the mold is abnormally lowered, it is not allowed to inching operation, especially after the mold stopper is plastic. 5. Turn off the punch host and other power supplies after the mold is lowered to avoid waste of resources. 6. When the mold is normally stopped, the mold needs to be moved until the guide pin enters the round hole of the material belt. (Prevent the material from retreating caused by the feeder not clamping the material when there is no air pressure and causing the tape to be entangled.) It is strictly forbidden to stop the mold at the bottom of the die. point. (It is easy to cause the service life of the spring in the mold to be reduced)