Precautions for installation of plastic wood stainless steel buckle

When the buckle is installed, the operator mainly judges whether the buckle is installed in place through the feel and sound. Therefore, the following points should be paid attention to when designing: 1), select the appropriate amount of deformation. The buckle realizes the installation through the deformation and rebound of the fastener. However, too small deformation is easy to cause unstable installation; too large deformation is easy to cause installation difficulties or even failure, and damage the buckle. 2). When designing, pay attention to some obvious phenomena when the buckle is installed and resting, such as changes in sound and feel. 3). When designing, pay attention to the number of constraints of the buckle, and there should be no over-constraints. Too many constraints require high machining accuracy of parts. In the actual assembly process, it is easy to cause the installation to be improper or impossible to install. Previous post: Introduction to the stamping process