Precautions for oil injection in stamping parts processing

In the processing of stamping parts, the amount of oil injection and the number of times of oil injection have certain regulations. The amount of oil and the number of times of oil injection depend on the conditions of the stamping parts processed; in the stamping parts processing, cold-rolled steel plates, corrosion-resistant For non-rust and non-scaling materials such as steel plates, the mold should be filled with oil. The oil injection points are the guide sleeve, the oil injection port, the contact surface between the cutter body and the guide sleeve, and the lower mold. Use light engine oil; in the processing of stamping parts, for rusty and dirty materials, the rust powder will be sucked between the punch and the guide sleeve during processing, resulting in dirt, which prevents the punch from sliding freely in the guide sleeve. In this case, if Oiling will make the rust more likely to be stained, so when flushing this material, on the contrary, wipe the oil clean, decompose it once a month, use gasoline (diesel) oil to remove the dirt on the punch and lower die, and reassemble Wipe clean before, so as to ensure that the mold has good lubrication performance; Recommended article: What information can stamping parts processing plants see on the waste? Previous post: Several ways to adjust the gap of metal stamping parts die