Precautions for pressing groove of stamping die in stamping processing factory-hardware

When designing continuous stamping dies, designers of stamping processing plants often add pressure grooves in the molds in order to ensure the quality and accuracy of the products. So what details should be paid attention to in the design of the pressing groove? Xiaoshuo shares with you: Because the pressure trough and the limit post are used together to control the gap of the product strip in the mold, the stripper is designed with a pressure trough, so when designing the limit post (some places call it The height of the column is the height-limiting column, haha.), this pre-compression depth should also be taken into consideration to reduce the adjustment time of the fitter during mold assembly and speed up the progress of the mold. For example: the product material thickness is 0.20mm, and the stripper plate pressing groove can be designed to be 0.05mm, then the height of the limit post on the lower template can be designed as: the thickness of the lower template + (0.20mm-0.05mm), if the thickness of the lower template If it is 25.00mm, then the height of the limit post on the lower template can be designed as: 25.00mm+(0.20mm-0.05mm)-0.03mm strong pressure u003d 25.12mm, so that's it, if strong pressure is left 0.03mm is almost the same. If the height of the limit post is designed to be 25.15mm, the strong pressure will be gone at this time. This is unreasonable. It is better to leave a little strong pressure, 0.03mm is enough. Don’t design it so dead. With 15 years of rich experience in hardware, more than 20 Ru0026D and design engineers, 5,000 square meters production workshop, daily production capacity of 3 million punching times and 16 quality inspection procedures, when you choose a stamping parts processing plant, you can quickly solve your time needs, A partner for precision and quality requirements!