Precautions for stamping parts

1. Semi-automatic and manual punching machines must be equipped with two-hand brake switches, and it is strictly forbidden to press with pedal or one-hand start switch. 2. After the high-stroke machine is adjusted, and after normal stamping, close the soundproof box (except for the 8065 side inspection side packaging of the product). 3. During continuous punching, employees cannot take the product by hand within 1M of the punching machine. 4. When the technician is on the mold and adjust the machine, only one person can debug, not two people to debug. 5. The technician can adjust the machine and feed the material, only outside the machine, and the distance is not less than 1M. 6. Be sure to tighten the screws when setting up the mold, and stop the machine for 4 hours to check if the screws are loose. 7. When there is a problem in the production process of the mold, there is no need to remove the mold. When it is directly repaired on the machine tool, the power supply of the injection molding machine must be turned off and the repairing sign can be hung on the power box before the mold repair can be implemented. 8. All tools are returned to the toolbox after use, and can not be placed on the machine table to prevent the tools from slipping and hurting people. 9. When the machine is not in production, cut off the power supply in time. 10. For short and small workpieces, special tools should be used instead of direct feeding or picking up by hand. Related news: The characteristics of the main materials of stamping parts, the handling of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections