Precautions for the installation and debugging of the mold of the CNC bending machine

What are the precautions for the installation and debugging of the CNC bending machine mold? The CNC bending machine mold is composed of many parts, so the state of the equipment must be checked when installing, and the steps must be strictly followed, and at the same time during the installation and debugging Pay attention to safety during the installation and debugging process of CNC bending machine molds.

1. The adjustment of the machine. Before installation, the performance of the machine must be adjusted first. This process must be carried out patiently and carefully. Check whether the machine has dust and used iron scraps, etc., and perform necessary cleaning. , In order to reduce the trouble in the later stage.

2. Adjust the stroke of the slider. Pay attention to check the thickness of the mold and check whether the ratio of the upper and lower modules is normal. Normally, the module should be controlled at the switch point of the stroke line. This must be paid attention to.

3. The adjustment of the stroke module is to adjust the upper limit point of the module. When the module reaches the highest point, set the switch and reserve the position of the slider, and also when going down It is necessary to carry out the deceleration module to better protect the machine and mold.

4. The adjustment of the gap is mainly to measure the distance between the upper module and the lower module. The specific gap setting is determined according to the folded plate.

5. Angle adjustment. The adjustment of this angle has a certain relationship with the product. Generally speaking, if you fold a 90° mold, the middle angle must be greater than the angle on both sides, so its tightness can be carried out according to the adjustment screw. When bending, the pressure can be adjusted through the pressure gauge to avoid die chipping.