Precautions when processing precision metal stamping parts

Precision metal stamping parts production_Metal stamping parts processing_What are the precautions when processing precision stamping parts? Now Xiaoshuo takes you to understand the inside story. 1. Before the machine works, check whether the moving part is filled with lubricating oil, then start and check whether the clutch and brake are normal, and run the machine idling for 1-3 minutes. It is strictly forbidden to operate when the machine is faulty. . 2. Maintain the correct posture at work and have sufficient energy to cope with the work. If you find that you are unwell, you should leave the job immediately and report to the leader. When operating, you must concentrate your thoughts, strictly forbid chatting, and cooperate with each other. The operator must not operate in a state of irritability and fatigue, so as to avoid accidents and ensure safe operation. Before entering the work position, all employees check whether their clothing meets the job requirements. Slippers, high heels and clothing that affect safety are not allowed, and those with long hair must wear a safety helmet. 3. When changing the mold, first turn off the power supply, and then start to install and debug the mold after the press movement department stops running. After installation and adjustment, move the flywheel by hand to test punch twice to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the blank holder is in a reasonable position. 4. Wait for all other personnel to leave the machine working area and remove the sundries on the workbench before starting the power supply to start the machine. 5. When the machine is working, it is forbidden to reach into the working area of u200bu200bthe slide block, and it is strictly forbidden to pick and place the workpiece by hand. Use standard tools when picking and placing the workpiece in the die. If you find any abnormal sound or malfunction of the machine, you should immediately turn off the power switch for inspection. After the machine is started, one person transports materials and operates the machine. Others are not allowed to press the electric building or step on the foot switch board, let alone put their hands in the working area of u200bu200bthe machine or touch the moving parts of the machine with their hands. 6. When leaving get off work, turn off the idle power and arrange the finished products, side materials and sundries on the job to ensure a clean and safe working environment. Hardware-The product accuracy reaches 0.01MM, the daily output is 3 million strokes, and the mold can be produced in 4 days. Strictly abide by the confidentiality agreement. You need to know more inquiries: