Precision metal stamping parts processing, an effective recipe for stamping dies to 'extend life'

For precision metal stamping parts processing, if you want to increase the production accuracy of the mold and make the mold more 'extend lifeSo please perform the following procedures carefully. 1. Clean and oil the keyway and inner diameter of the turret hole.　2. Adjust the keyway of the upper die guide sleeve to match the key of the turret hole.　3. Insert the upper die sleeve straight into the tower hole, being careful not to have any tilt. The upper die guide sleeve should slide into the turret hole by its own weight.　4. If the upper die sleeve is inclined to one side, use a soft material tool such as a nylon hammer to tap it lightly. Repeat percussion until the upper die guide sleeve slides into the correct position by its own weight.　Note: Do not apply force to the outer diameter of the upper die guide bushing, only apply force to the top of the punch. Do not knock the top of the upper die sleeve to avoid damage to the turret hole and shorten the service life of individual stations. Hardware, 15 years of ingenuity focused on precision metal stamping parts processing, 20,000+ sets of mold customization production experience, monthly 100+ sets of mold processing capacity, daily production capacity of 3 million punching times, stamping accuracy up to 0.01mm, 16 quality inspection layers are strict check. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, the choice is peace of mind and peace of mind!