Press operating standards

Explanation

Preparation before starting

(1) Check all parts of the machine;

(2) Check whether the voltage is normal.

Boot

(1) First turn on the power switch and start the motor;

(2) Check whether the punch press is operating normally, and rotate the punch press with air pressure;

(3) Load and drop the mold, lock the upper mold, and fix the lower mold; the upper and lower molds must be in balance; the punching force is moderate;

(4) When stamping products, only one product can be punched at a time (except for automatic punching), and the machine cannot be used to punch the same product more than twice in a row to avoid damage to the mold;

(5) Each time the upper punching die rises to the top position, feed the material in the direction for the second punching.

Tuning

(1) According to the pressure of the product Adjust the height and position of the mold, and the intensity is moderate;

(2) Whether the product (stamping) meets the sample and meets the quality requirements;

(3) Trial adjustment machine with waste materials;

(4) Adjust the machine with positive materials.

Notes

(1) Clean the machine and the dirt around the mold before and after starting the machine;

(2) Check the operation of the machine and the initial inspection of the product at any time;

(3) When stamping the product, if the product sticks to the upper mold or falls on the lower mold, it is strictly forbidden to take it directly by hand. Use tweezers or other safe methods to avoid accidental damage to the machine.

(4) If an abnormal situation occurs, immediately turn off the power and shut down for inspection.

Remarks: Stamping (press) is divided into automatic and semi-automatic. The above content is a semi-automatic press; its automatic press generally refers to the above content for operation, except for items 4 and 5 of the start-up item.