Processing defects of scaffolding stamping parts

In the process of processing and manufacturing scaffold stamping products, some defects will inevitably occur. So when we encounter different defects, how can we solve them? Below we have selected a few of the more common problems to share with you, hoping to help you, let's take a look at the specific content! The first situation: the quality of raw materials used in scaffolding stamping products is inferior. In response to this problem, we must pay attention to it, and in the production process, we must ensure that the raw materials used are consistent with the specified technical conditions. In other words, in actual work, we need to strictly control the quality of raw materials and carefully check the specifications and grades of raw materials. If possible, it is best to conduct laboratory inspections on workpieces that require high dimensional accuracy and surface quality. The second situation: there are some unreasonable problems in the installation, debugging or use of the die of the scaffolding stamping parts. For such a situation, then we should ensure that the production process should be implemented in accordance with the requirements of the process regulations, while ensuring that each link strictly abides by the corresponding system and requirements. The third situation: because the die of the scaffold stamping parts has been used continuously for a long time, the gap has changed, or the working parts and guide parts of the scaffold are worn out. Regarding this issue, we require that a strict inspection system must be established in actual production. Only by ensuring that the production is qualified can it be put into production. At the same time, the inspection should be strengthened to deal with the accident in time. In the last case, because the die of the scaffold stamping parts has been vibrated for a long time, the fastening parts of the scaffold are loosened or fall off, and finally the installation positions of the die are relatively changed. In response to this problem, we need to strictly adhere to a civilized production system, and to ensure the use of appropriate workstations and equipment. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections