Protection measures in the process of hardware terminal products1

Widely used in electronic industry are increasingly changing the human production and way of life, as in the electronics hardware terminals, it is very important for the precision and requirements in electronic products. 1, hardware terminal product material selection and distinguish: A: common material is divided into: C5210 C5191 C2680 SUS301 SUS304 SUS201 SPCCB: each depending on the hardness of the divided into: 1/2 H H EH SH 3/4 hc: : common phosphorus copper quality as: C5210H/EH C5191H/EH phosphor copper is reddish brown, phosphorus copper has good elasticity hardness strong, has the good electrical conductivity, not easy fever, ensure security at the same time have the very strong resistance to fatigue. Tin phosphor bronze jack reed hardwired electrical structure, no rivet connection or no friction contact, ensures good contact, good elasticity, smooth dial. Common green ( Yellow) Copper mass is: C2680H/EH copper has: brass is golden, toughness good conductivity low resistance resistance properties. Common stainless steel material for: SUS3011 SUS3043/4 h / 2 h SUS304 stainless steel: it has good corrosion resistance, heat resistance, low temperature strength and mechanical properties, punching bending such as hot workability is good, hard phenomenon without heat treatment, non-magnetic. Protection measures in the process of synthesis of 2, terminal products in: (1) the paper plates, paper USES the paper harder K = K, not easy fracture and deformation. Have the effect of the first level protection terminal. (2) the thickness of the styrofoam, note must be higher than the width of the product, in case the crooked PIN terminal products, as well as the deformation. The thickness of the paper for terminal shape, can use 0. Thick 1 or 0. 2 thick paper tape. 3, the subclass product each plate must be folded plate, look for products (climb up, as well as the crooked PIN. 4, plateful packaging, terminal head not show tape products. 5, the subclass product to each dish, add square styrofoam to support disk, prevent deformation caused by the high product stack. 6, use a hard paper box packing carton, the four corners and protection support, to ensure that every product in the process of transportation is not squeezed or damaged due to turbulence. Metal stamping mold factory for precision terminal customer product requirements and special performance, using the best quality raw materials, in process technology, the size of the strictly meet customer requirements, in the packaging and shipping, effectively protect the product from being damaged. In this paper, starting from the original, if reprint please indicate the source and the author