Punching method without burrs in a stamping factory-hardware

The burrs in the production of the stamping processing plant are generated at the time when the metal raw material is broken. As a method of controlling fracture, the gap can be made smaller. Therefore, if the gap is to be made extremely small, the punch is advancing and the shearing is advancing, and the material is hardened, and fracture naturally occurs. However, because of the small gap, the punch and die break before they meet, and the phenomenon of shearing will occur again. This situation is the secondary fracture phenomenon, and sometimes the cause of serious burrs. As a good production, if you want to solve the burrs, it is necessary to consider the processed material and the thickness of the plate. The method of punching through the material, even if the gap changes, the punching without burrs is related to the wear state of the punch and die in the early stage. Therefore, efforts must be made in the separation after the push, so that the two sides must be treaded. Press to form a flat pressing method. Hardware, 15 years of ingenuity and focus on stamping processing plants, monthly processing capacity of 100+ sets of stamping dies, daily production capacity of 3 million, and 16 quality inspection procedures to strictly control the quality. Quickly solve your time-critical issues, product accuracy issues, and bulk quality issues. Choose, choose to rest assured!