Reasons and preventive measures for scraps of scaffold stamping parts

In the production process of scaffolding stamping parts, some waste products will inevitably appear. These waste products will not only affect the efficiency of production, but also cause waste and increase production costs. So why is there such a problem? If such a problem arises, what measures should we take to deal with it? With this question, let’s look at the following. First, we need to analyze the specific reasons. In fact, if there are waste products in the processing of scaffold stamping parts, it is nothing more than the following reasons: first, the quality of the raw materials used is poor; second, the installation and adjustment of the die is unreasonable or improper operation; third , The operator did not feed the strip according to the correct requirements, or did not leave a proper gap for feeding as required. In addition to the above three reasons, there are two other reasons that are more common. The first is that the die has been slightly deformed due to long-term use, or there is a certain degree of wear; the second reason is Due to shock or excessive vibration time, the parts are loose. In addition, if the operation is not careful enough, it may also cause the scaffolding stamping parts to appear scraps. So, how can we prevent such problems? For this problem, we first need to select better quality raw materials for production, and secondly, in the entire processing process, we need to strictly follow the standards and requirements. For the processing equipment used, it should be ensured that it is always in normal working condition. Finally, in the production process, a strict inspection system should be established to closely contact the quality of scaffolding stampings. In addition, in the process of adopting, we should also pay attention to the cleaning work to ensure that the equipment, molds and the entire work link are clean, so as not to affect the production quality of scaffold stamping parts. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections