Ronggui metal stamping parts processing plant, some stamping common problems + hundreds of processing and production equipment

The production staff of Ronggui hardware stamping parts processing plant once said that in the daily stamping production, the punching size may be too large or too small (may exceed the specification requirements) and the size of the punch may differ greatly, except for consideration In addition to the design dimensions, machining accuracy and blanking gap of the forming convex and concave molds, Xiaoshuo thinks that the following aspects should also be considered to solve the problem. 1. When the punching edge is worn, the tensile stress on the material increases, and the tendency of the stamping parts to turn over and twist increases. When turning over, the size of the punching hole will become smaller. 2. The strong pressure on the material causes plastic deformation of the material, which will cause the punching size to become larger. When the strong pressure is reduced, the size of the punching hole will become smaller. 3. The shape of the edge of the punch blade. If the end is trimmed with a slope or arc, the punching force is slowed down, and the punching part is not easy to turn over and twist. Therefore, the punching size will become larger. When the end of the punch is flat (no bevel or arc), the punching size will be relatively small. Hardware, 15 years of focusing on Ronggui hardware stamping parts processing plant, 20,000+ sets of stamping die customization production experience, monthly 100+ sets of mold processing capacity, hundreds of precision processing production equipment, daily production capacity of 3 million punches, silk-like stamping accuracy Up to 0.01mm, the raw materials are imported and the original national standard factory, and 16 quality inspections are strictly controlled. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!