Safety hazards and points for attention in the process of making metal stamping parts

Safety hazards in the process of making metal stamping parts and attention to personal safety issues. In the dangerous area of u200bu200bthe machine tool, if any part of the human body comes into contact with the machine tool during the working process, it may cause personal injury. Dangerous zone refers to the range of the upper and lower table. Generally, there are these types: a machine tool wire short circuit will cause the machine tool to move suddenly, the emergency stop button is poorly contacted, sometimes not, and more than three people are not coordinated when operating. Assure, in the third case, someone can only cherish themselves. Material belt hazard. The stamped material belt is very thin, just like a knife edge. I am most afraid of not seeing the material belt trip when retreating. In severe cases, the heel muscle key may be broken and the limbs below the head may be paralyzed. Thermoplastic workshop It is necessary to prevent injuries and harmful gases. Noise hazards, the general stamping factory does not equip employees with earplugs, which will damage the hearing after a long time. Product burrs, some products have large burrs, so you should wear protective gloves on site. Oil hazards. The oil used for stamping is industrial oil, which should not be in contact with the skin for a long time. The other is the common hazards that are common in daily life. As an old employee, I would like to remind you that as long as you follow the formal operating procedures, there is no problem. This includes: not hurting others, not hurting yourself, not being hurt by others. The stamping machine is vertical. When the worker loads the workpiece, the hand must be put into the stamping area. There is a safety hazard. Is there a device that does not take out the worker’s hand in time after stamping, and it will automatically stop when it senses the hand. When metal stamping parts, the operator should mainly wear gloves to work, otherwise the metal plate has burrs and cause harm to the human body. Previous: The production process of metal stamping parts