Safety rules and civilized production requirements for precision stamping parts

When making machinery, workers’ safety is very important, so it is very meaningful to be familiar with the safety rules of stamping parts and the requirements of civilized production. Today the editor introduces these two contents as follows: 　　1. Safety rules (1) Wear overalls at work, Female comrades wear work caps. They must press their long hair into the caps. High heels are prohibited in the workplace.　　 (2) When working, you must concentrate, and pay attention to your hands, body and clothes not close to rotating parts, such as belt wheels, flying guns, gears, etc.　　(3) Chess tool clamping must be firm and reliable. It is forbidden to be over-loaded to be operated. It is not allowed to enter the mold and the machine tool itself is damaged. Even the mold is damaged. The fragments fly out and hurt people.　　(4) When working. Don’t work with fatigue. Work after drinking is strictly prohibited.　　(5) When operating the press, the right foot cannot be kept on the operating pedal.　　(6) When loading and picking up the punched parts, use special tools to operate. It cannot be grabbed directly by hand.　　(7) Do not disassemble and assemble electrical equipment at will. To avoid electric shock accidents.　　(8) If there is a fault in the machine tool and electrical equipment of the inkstone during work, it should be reported in time. 　　 be overhauled by professionals. If it is not repaired, it cannot be used.　　Second, civilized production requirements　　 (1) Before starting, check whether the various parts of the machine tool and protective devices are intact. 　　 Whether the operating mechanism is flexible. Whether the position is correct, and check each oil hole for lubrication. When in use, the punch flywheel can only work after it runs normally. If any problem is found, stop using it immediately. Report for maintenance.　　(2) When installing, disassembling and changing molds, you must stop the machine before debugging the mold. When manpower is required to move the flywheel, the power should be turned off.　　(3) The placement of work and measuring tools should be stable, tidy and reasonable.