Scaffolding stamping parts die trimming and iron filings are related to process design

In actual work, when trimming the mold of the scaffold stamping parts, the problem of iron filings may occur. Especially in the vicinity of the scrap knife of the lower mold, this problem is more serious. This problem will not only affect the quality and appearance cleanliness of the processed products, but also have a great negative impact on the production work, which may lead to a decrease in production efficiency. Therefore, in response to such problems, we need to take timely countermeasures to deal with them. After analysis, one of the most important reasons is that the mold process design of the scaffold stamping parts is unreasonable. So, what effective measures should we take in response to this situation? After analysis, we can take three measures to solve the problem. The first is to improve the trimming method of the separation zone in the middle of the double piece. In the original production process, the upper die press core and the lower die punch are used to press the plates together, and then the waste material is separated by the upper and lower die scrap blades. After improvement, the upper die is used to break through the knife to forcibly cut, which will form a larger chip removal space, thereby providing convenience for the trimming and discharging of the scaffold stamping die. Secondly, we can also take two or more trimming methods to alleviate this problem. In comparison, after switching to this method, if the blade gap is reasonable, there is no need to worry about burrs or trimming iron filings, and it is also easy to eliminate waste. In addition, the quality and production efficiency of scaffolding stamping parts can also be improved. Finally, we can also use the whole side trimming method to solve this problem. Because after changing to this method, it can be ensured that there is no problem of burrs or trimming iron filings when the blade gap is reasonable. More importantly, the quality of scaffolding stampings can be significantly improved. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections