Separation of stamping parts and analysis of forming process

The production and processing of stamping parts include different processes, and after these processes are processed, the production of stamping parts is completed. For example, the separation process is one of the processes, which refers to a basic stamping process in which materials are separated in the mold. The processing content can be completed according to different processing requirements, which can account for about half of the entire stamping process content. Next, we will focus on the forming process of stamping parts. The forming process also includes different processing contents, namely bending, stretching, stretching and pressing. In order to facilitate your study and understanding, we will discuss these four parts below, hoping to help you. The first one is bending, which is also a very important part of the processing and production of stamping parts. Specifically, it is a plastic forming method for different pre-selected plates according to predetermined requirements with a certain angle, curvature and shape. For the bending of metal materials, it can be regarded as an elastoplastic deformation process. When the pressure is removed, a certain elastic recovery will occur, called springback. In actual production, in order to ensure accuracy, this issue needs to be considered. Next is the drawing. For different materials and stamping products, we need to set the corresponding processing methods and standards in advance. This is because in the production of stamping parts, it is necessary to consider the geometric characteristics, the location of the deformation zone, the nature of the deformation and the distribution of the deformation, etc., to select the corresponding process parameters, number of procedures, and mold design principles and methods. Then there is the stretch. In the production and processing of stamping parts, we can choose different processing methods for different processing objects. Under normal circumstances, the applicable objects of the stretch have certain special requirements, and because the process is relatively simple, the cost is relatively cheap, but the disadvantage is that the material utilization rate and productivity are low.　　 In addition, there is another process called pressure. In the production of stamping parts, we will need to choose the corresponding processing method according to different situations. Related news: The characteristics of the main materials of stamping parts, the treatment of common problems of stamping parts, the characteristics of scaffolding stamping parts and the importance of inspections