Shanghai Precision Stamping Co., Ltd., every progress is a feedback to customers

Shanghai Precision Stamping Co., Ltd. learns from itself at work, summarizes the work in the study, continuously learns and grows, and constantly uses knowledge to make its work more valuable. Most manufacturers will follow such a cyclical process. Yes, in fact, every bit of progress made by the stamping factory can always give back results to customers. Next, Xiaoshuo will take you to understand the little progress in the mold: 1. Simple die A simple die is a die that only completes one process in one stroke of the press. When working, the strip is fed along the two guide plates on the die until it hits the positioning pin. When the punch is punched downward, the punched parts (or waste) enter the hole of the concave die, and the strip clamps the punch and moves upward along with the punch. When the strip hits the discharge plate (fixed on the die), it is pushed down, so that the strip continues to be fed between the guide plates. Repeat the above action to rush down N two parts. 2. Continuous die A die that completes several stamping processes on different parts of the die at the same time in one stroke of the press is called a continuous die. When working, the positioning pins are aligned with the pre-punched positioning holes, the upper mold moves downwards, the punch is blanked, and the punch is punched. When the upper die returns, the unloading plate pushes down the waste from the punch. At this time, the blank is fed forward, and N secondary blanking is performed. This cycle is carried out, and each feeding distance is controlled by the stopper pin. 3. Compound die In one stroke, a die that completes several stamping processes on the same part of the die at the same time is called a compound die. The characteristic of the compound mold is that there is a convex and concave mold in the mold. The outer circle of the convex and concave mold is the cutting edge of the blanking punch, and the inner hole becomes the drawing concave mold. When the slider moves downward with the convex and concave molds, the strips are firstly blanked in the convex and concave molds 1 and the blanking concave mold. The blanking piece is resisted by the drawing punch in the lower die, and when the sliding block continues to move downward, the female die will move downward for drawing. The ejector and the unloader push the drawn part out of the mold during the return stroke of the slider. Compound molds are suitable for stamping parts with large output and high precision. Hardware, 15 years of ingenuity and focus on Shanghai Precision Stamping Co., Ltd., 20,000+ sets of mold custom processing and production experience, 3 million punching next-day production capacity, stamping accuracy up to 0.01mm, 16 quality inspection processes are strictly controlled. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose to rest assured!