Shishi hardware stamping parts processing factory, manages the production protection when stamping + 15 years of experience to show you

In the case of producing dozens or hundreds of stamping parts per minute, processes such as feeding, stamping, discharging, and discharging waste are completed in a short period of time. Personal, equipment, and quality accidents often occur in such an operating environment. Therefore, the stamping production staff of the Shishi hardware stamping parts processing plant said that the protection of production during stamping has always been a very important issue. Xiaoshuo sorted out some effective protective measures, and let’s take a look at them: The protective measures for stamping processing have the following points: ①Realize mechanization and automatic feeding and discharging. ②Set up mechanical protection device to prevent hand injury. Use mold guards, automatic return devices and hand tools to feed in and out. ③Set up electrical protection and power-off devices. Set up photoelectric or air curtain protection switch, two-hand or multi-hand series start switch, anti-misoperation device, etc. ④Improve the clutch and brake structure. After the danger signal is sent out, the crankshaft, connecting rod, and punch of the press can immediately stop in their original positions. The various parts on the mold should have sufficient strength and rigidity to prevent damage and deformation during use. The fastening parts should have anti-loose measures to avoid accidental injury to the operator. It is not allowed to produce waste or workpiece missiles during the processing, which will affect the attention of the operator or even hurt the operator. In addition, it is necessary to avoid cuts from the burrs of the blanking parts. Operators are not allowed to have too much motion range during the stamping operation, to avoid losing the body's stable posture; excessive and over-accurate movements are not allowed during operation. Hardware, 15 years of focusing on Shishi hardware stamping parts processing plant, hundreds of processing and production equipment, 20,000+ sets of customized stamping die production experience, monthly processing capacity of 100+ sets of molds, daily production capacity of 3 million punches, and stamping accuracy up to 0.01mm , 16 quality inspection layers are strictly checked, focusing on quality and meticulous design. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose to rest assured!