Stainless steel stamping parts, with technology and experience to achieve customer satisfaction

Before making stainless steel stamping parts, designers need careful mold design. How to make a set of high-quality stamping dies has an important relationship with efficiency and quality in production. Xiaoshuo briefly summarizes a few points and shares with you: 1. Before designing the material belt, be sure to understand the tolerance requirements of the parts, material properties, punch tonnage, punch table, SPM (strokes per minute), feeding direction, feeding height, Mold thickness requirements, material utilization, mold life. 2. Special deep-drawn stainless steel materials can be annealed after pre-stretching. With a high-frequency annealing machine, the thinning rate can be accepted to 40%. When designing the strip, the empty step is also very important. The mold length allows In the case of the circumstance, leaving an empty step appropriately will be of great help to the modification after the test. 3. In the mold design, for the surface with small hole position or tolerance requirements, make adjustable inserts as much as possible, which is convenient for adjustment during mold trial and production, so that it can be easily achieved. The size requirements of the parts must be made at the same time Adjustable inserts. For the word mark, it is required to be dismantled on the punching machine, and there is no need to dismantle the lower mold, which is a waste of time. Hardware, 15 years of ingenuity focused on stainless steel stamping parts, 20,000+ sets of mold customization and production, monthly processing of 100+ sets of molds, daily production capacity of 3 million punching times, stamping accuracy up to ±0.01mm, and 16 quality inspections strictly. Various types of stainless steel design, mold making and production and post-processing experience of stainless steel stamping parts. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems.