Stainless steel stamping processing, so that the results of the mold trial will make customers more satisfied

Stainless steel stamping processing, when the mold assembly is completed, it enters the stage of trial mold. At the same time, this is also a very important link before production. Xiaoshuo will take you to understand: 1. When you try the mold for the first time, you must slowly close the upper mold. For the stretching process, you must use it. The thickness of the fuse test material level. After the material level gap reaches the material thickness, try the mold again. The knife edge must be aligned first. Please use movable inserts to adjust the height of the drawbead. 2. When testing the mold, the reference hole and reference surface must be equipped with the mold before placing the product on the gage for measurement, or sending it to CMM for 3D report, otherwise it is meaningless. 3. The red pill must be well matched, and the fit rate is above 80%, before the cut can be opened and the CMM report can be made, or the reference hole datum surface has been matched, the product is very stable, and the fit rate can be appropriately reduced. It is very important to mix red lead, otherwise the product will be unstable and the later model modification cannot be judged. Hardware, 15 years of ingenuity focused on stainless steel stamping processing, 20,000+ sets of mold customization and production, monthly processing of 100+ sets of molds, daily production capacity of 3 million punches, stamping accuracy up to ±0.01mm, and 16 quality inspections strictly. Various types of stainless steel design, mold making and production, and post-processing experience in stainless steel stamping. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems.