Stamping mold design

Stamping die is the main process equipment, stamping processing of stamping parts is depends on the relative motion of upper and lower die to complete. In structure should keep feeding, materials, parts, easy to clean up the waste. For large parts of processing, if the operator must hand into the mold, as far as possible reduce the range into the mold, shorten a portion of the form as much as possible in the time duration of the mould, and shall specify the mould of danger area, equipped with the necessary protective measures and devices. The various parts of stamping mould should have sufficient strength and stiffness, prevent damage and deformation in the course of using, fastening parts must have the loose prevention measures, avoid accident harm to the operator. Not to be allowed to happen in the process of processing waste or workpiece missile phenomenon, affect the operator's attention, even by the operator. In addition to avoid burr blanking pieces cut staff. Don't allow there is too much and too difficult movements in my homework. Avoid stamping processing has strong noise and vibration. Stamping die design the general layout of should indicate the mold weight, easy to install, ensure safety. More than 20 kg parts processing should be lifting handling measures, reduce labor intensity. Mold storage to facilitate disassembly. In short, even a minor problem in mould will affect the safety, only to analyze the specific problems of each homework, can put forward security considerations in the mould. In this paper, starting from the original, if reprint please indicate the source and the author