Stamping parts manufacturers reveal the operation process of stamping parts inspection tools for you

Stamping parts manufacturers reveal the operating process of stamping parts inspection tools for you　　

1. According to the program of the product P.C.M, draw a schematic diagram of the inspection process and determine the inspection procedure.

　　 2. The burrs on the edges must be removed before the product is placed on the main test body. After the main test body is placed, the accuracy of the positioning hole core should be checked first.

　　3. After the product is smoothly inserted into the positioning hole core on the main test body, fix the serial numbered compacts on the main test body in turn, and press the product (the product is supported by the standard pad on the main test body From).

　　 Four. Use a special plug gauge to insert each hole on the product and into the hole sleeve at the corresponding position of the main inspection body, and check whether each hole and hole core are within the qualified range.

　　 5. Use a special plug gauge to check the vertical fluctuation of the size at the edge of the product and the main inspection body, and use the matching insert on the side of the main inspection body to check the horizontal fluctuation of the size at the edge of the product's shape.

　　6. Use a special inspection board to check the depth and shape of the product at each prescribed profile, and check the gap with a feeler gauge to determine the quality of the place.

　　 Seven. Use the inspection board on any curved surface to check the distance (given value) between the upper surface of the product and the lower surface of the inspection board at the specified coordinate position with a special plug gauge to determine the The quality of the section.