Stamping parts processing plant talk about three views of stamping die

How to look at the three views of the mold in the stamping parts processing plant? Let's briefly talk about it; the three views of the mold in the stamping parts processing plant are viewed from the front, and the geometric figure obtained is called the front view; when viewed from the back, the geometric figure obtained is called the rear view; The geometric figure is called the left view; the geometric figure obtained from the right side is called the right view; the geometric figure obtained from the top down is called the top view, and the geometric figure obtained from the bottom up is called the top view. The figure is called the bottom view; the mold drawing in the stamping parts processing plant should be more accurate, more readable, and easy to understand. Sometimes it is necessary to draw a cross-sectional view, a full view, a half-sectional view, and a cross-section. Figures, etc.; cross-sectional view, which is the figure seen by cutting it, full section view, is the figure obtained by cutting it completely, half-section view; it is the figure obtained by cutting it in half; broken figure; it is to show that the object is broken from here, The view displayed after the fracture is also called the cross-sectional view; the source of the article: the principle of chrome plating of cold metal stamping parts Previous: The stamping process of sheet metal stamping parts processing