Suzhou electronic hardware stamping parts processing, the cause of turning material distortion + 15 years of stamping experience

What are the reasons for turning and twisting during stamping? The technicians of Suzhou electronic metal stamping parts processing have mentioned this kind of related knowledge. Xiaoshuo has compiled some information, and let everyone know about it: The shape of the piece. The main reason for the turning and distortion of the punching parts is the influence of the punching force. When punching, due to the existence of the punching gap, the material is stretched on one side of the die (the material is warped upward) and compressed on the side of the punch. When using the unloading plate, use the unloading plate to compress the material to prevent the material on the die side from warping upwards. At this time, the force of the material changes accordingly. As the discharge plate increases its pressing force, the material on the punch side is stretched (compression force tends to decrease), while the material on the concave die surface is compressed (tension force tends to decrease). The overturning of the stamping part is caused by the stretching of the material on the die surface. Therefore, when punching, pressing and pressing the material is an important point to prevent the punching from turning over and twisting. Hardware, 15 years of ingenuity focused on metal stamping parts processing, 20000+ sets of stamping die customization production experience, monthly 100+ sets of mold processing capacity, daily production capacity of 3 million punches, stamping accuracy up to 0.01mm, 16 quality inspection layers are strict check. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose to rest assured!