The difference between uncoiling blanking and ordinary blanking in stamping parts processing

There is a difference between uncoiling blanking and ordinary blanking in the processing of stamping parts. The specific performance is the following aspects. Let’s take a look at it below: 1. The parts in the stamping part processing are relatively large, and the manual operation of labor-intensive parts should be as much as possible. Use uncoiling blanking; 2. Compared with ordinary blanking dies, the parts that can improve the material utilization rate of stamping parts use uncoiling blanking; 3. The width of the coil material required in the processing of stamping parts is too small or too wide to be used For uncoiling blanking, ordinary blanking mode is required; 4. For parts produced on the automated line according to the planning of the part process route, most of the blanking dies use uncoiling blanking; recommended article: several kinds of drawing parts in metal stamping parts Previous post: Common problems of stainless steel stamping parts in daily processing