The principle of layout of stamping parts production

The stamping factory can produce all kinds of precision stamping parts, automobile stamping parts, electronic stamping parts, etc. Only with the participation of various processing procedures can qualified stamping parts be produced. As long as it is production, it is inseparable from product layout. Today, Precision will give you a main analysis of the principles that the stamping factory should abide by when making stamping parts layout. 1) The rough map of the finished product is continuously tried out on the drawing surface. After the direction is basically clear, the punching machine, cutting, cutting waste and other stations are allocated at one end, and then the forming stations are allocated to the other end. 2) Consider the indispensable position to improve the compressive strength of the mold. When the continuous stretching frequency is high in the processing of stamping parts, a reserved empty station is added after the initial stretching to facilitate the increase of the stretching frequency. 3) In the processing of stamping parts, according to the total width of the strip, consider the selection of single and double rows or three rows to increase the utilization rate of raw materials. 4) Pay attention to the rolling direction of the raw material, the rolling direction can harm the actual effect of the economic development of the layout, and also the characteristics of the stamping parts. 5) The raw edges of the bending parts should be located on the inner side of the bending parts. 6) Consider whether it is necessary to side-edge trimming. For thin materials, guide pins can be used without trimming; for thick materials, trimming is required to prevent the guide pins from breaking. 7) Arrange the guide pins scientifically; 8) During the whole process of stamping parts processing, it is not allowed to have sporadic side material remaining on the surface of the mold. [Related recommendation] Learn more: What are the methods for polishing the surface of stainless steel? Learn more: Manufacturing characteristics of automobile stamping parts molds Learn more: Points to note in the design of continuous stamping dies (2)