The production of stamping parts should improve equipment, strengthen protection and adopt intelligent technology

Due to the excellent quality and good performance of stamping parts, many manufacturers are producing such products, but the qualified rate of products obtained by each manufacturer is different. This is because the production equipment and process technology used to produce stamping parts are all different. If you want to improve the quality of stamping parts, you have to start from these aspects. 1. Improving the quality of stamping parts by improving mechanical equipment. In addition to stamping equipment, the production of stamping parts requires corresponding molds. Through continuous research and improvement, not only the service life of the equipment has been significantly improved, but also The stamping parts produced have been further improved in terms of specifications and appearance quality. 2. Strengthen the protection analysis of ways to improve the quality of stamping parts. It is known that some defects of stamping parts are caused by defect protection devices. Therefore, when processing and producing stamping parts, you must use the installed protection mode to avoid In the production process, due to the small amount of processing, the processing personnel are not skilled, and the already manufactured stamping parts are damaged. 3. The way to improve the quality of stamping parts is to use intelligent stamping technology. This is because intelligent stamping technology can make the production of stamping parts into an automated state, not only can the production efficiency be higher, but also the accuracy and surface of the workpiece The quality can also be better presented. In addition, don't forget to strengthen the inspection and maintenance of related equipment, as well as the training of operators' skills. Only when all aspects are fully prepared, the pass rate of stamping products can be guaranteed.