The reason why simple stamping dies are not used as samples of precision stamping parts 'hardware'

After receiving the quotation for metal stamping products, many customers proposed to make simple stamping molds to make a few precision stamping parts samples for testing. For this type of customer, we recommend that you inform the customer not to do it at the beginning Simple mold. The main reasons are as follows: 1. Simple stamping dies cannot make precision stamping parts that fully meet the requirements of the drawings. The customer wants to use simple stamping dies to make samples of precision stamping parts. It is nothing more than that the product has not been confirmed in the early stage, and wants to spend a relatively small cost to test the samples. However, products made with simple stamping dies cannot guarantee dimensional accuracy, and even after customer testing, it is impossible to determine whether it is the cause of the product or the cause of unqualified dimensions. 2. Simple stamping dies cannot guarantee the unity of stamping parts. Simple stamping dies cannot guarantee that each stamping part is the same, because simple stamping dies are often not equipped with positioning, guide posts and other accessories. Each punching time will have different deviations, which will cause customers to perform stamping parts. Unable to get satisfactory results during testing. 3. The inability of simple stamping dies for mass production will lead to waste. The simple stamping die has a simple structure and low precision. After the customer confirms the sample of the precision stamping part, it cannot be mass-produced and can only be discarded. This leads to serious waste. In fact, if the customer has no confirmation of the stamping product, there is no need to open a simple stamping die to produce samples of precision stamping parts, and other processing techniques can be considered.