One Stop Solution Manufacturer for all kind of Stamping Products and CNC lathed products.
The use of drawing metal stamping parts-hardware
Hardware belt You understand the use of drawing metal stamping parts: Stretching metal stamping parts rely on pressure to quickly apply external force to the sheet, pipe and profile, etc., to cause plastic deformation or separation, so as to obtain the desired shape and shape. The forming and processing methods of workpieces of different sizes, stamping and forging are both plastic processing, collectively referred to as stamping blanks. Mainly hot-rolled steel and steel. The service life of metal stamping parts depends on the reasonable mold structure, high manufacturing accuracy, good heat treatment effect, and the correct selection of punches, drawing stamping parts installation accuracy factors, the correct use and maintenance of stamping parts die Maintenance is also a link that cannot be ignored. At the same time, we should pay attention to the following points: 1. Hardware stamping parts should be strictly inspected before installation and use, clean and remove dirt, and check whether the guide sleeve and die of the stamping parts are well lubricated. 2. When the punch and die edges of metal stamping parts are worn, they should be stopped and sharpened in time, otherwise it will rapidly expand the wear of the die edge, accelerate the wear of the die, and reduce the stamping quality and die life. 3. Ensure the service life of stamping parts, and the spring of the mold should be replaced regularly to prevent spring fatigue damage from affecting the use of stamping parts. In order to normal production, improve the quality of metal stamping parts, reduce costs, and extend the life of the die, bi must use and maintain the die properly, strictly implement the 'three inspection' system of the die, and do a good job in the die, maintenance and repair work. The above is the introduction of the hardware author. I hope it will be helpful to you. If you need more information about stamping parts, please consult the hardware that has been committed to the stamping parts industry for 15 years. Tel: