There are really a lot of problems with the metal stamping parts factory, see which ones you have

Since entering the stamping industry, I have come into contact with many metal stamping parts factories, and found that many stamping factories have more or less problems. The statistics mainly include the following aspects: 1. The process arrangement is unreasonable. Different stamping products have different operating strengths, and the operating strengths of different processes of the same product are also different. Some procedures are complicated and require long hours of work, while some procedures are simple and have been idle for a long time, which causes the utilization of workers and equipment to not be maximized. In normal production, some workers need to produce non-stop, while some workers are relatively idle. 2. The production plan is unreasonable and the product duration cannot be guaranteed. Calculated by the installation shape, size and thickness of stamping products, different products require different punch tonnages. Some hardware stamping parts factories have many equipment in a long-term idle state. 3. It takes too long to replace the stamping die. Stamping parts are all produced by molds, so many stamping factories need to make better stamping dies frequently. However, some metal stamping parts factories take too long to change molds, which greatly affects production efficiency. What's more, it takes time to find the stamping dies that need to be replaced when they are in use! 4. Lack of formal safety management regulations. There is no formal safety management standard, production is based on experience, and the placement of materials, products, equipment, etc. in the factory is very random. Workers are not trained in operation, and there are no measures to ensure production safety. 5. Unreasonable arrangement of workers. Stamping production needs to refer to the actual situation of each worker and arrange the most suitable position. When female employees are needed, it is necessary to arrange lighter work. In general, the job that is most suitable for the worker must be the most suitable for the worker to maximize his potential. Of course, the problems existing in the metal stamping parts factory are definitely not the only ones. This requires the boss of the enterprise to find the problem carefully and work hard to solve the problem. Previous: General process of stamping auto body panels