Tips for details: Matters needing attention in the decoration of bathroom tiles

Tips 1. Make the wall as rough as possible before tiling, so as to increase the contact force area between the cement and the wall. The specific method is to use an electric drill to drill more holes in the wall, the more the better. Some decoration companies now call this a haircut. I have not seen a specific method, but my bricklayer later told me that the method is not to deal with the wall, but to roll the glue on the wall first, and then shake the cement. On the wall, after the cement has solidified, it is pitted like the wall in the theater, and then tiles are placed on it. In fact, this does not increase the contact area between the cement and the real wall. I don’t make much contribution, so I think that the term “puffing” is actually a bit foolish.

Posting instructions 2. When tiling, the bricklayer must be required to pull the wire and supplemented by a level ruler. No matter how good the bricklayer is or how good it feels, it is recommended that you still insist on using tools to control the quality.

Posting 3. Generally, cement mortar can be used for load-bearing walls, but when tiling tiles on kitchen flue, bathroom air duct, kitchen and bathroom covered pipes, 108 glue must be added to the cement mortar to increase the stickiness. force.

Posting 4. When the decoration company is tiling, the tile trade union will hold a ruler made of large core board for you to check and accept it. In fact, the thing is not polished after a few times, so you can’t take that To check the quality of the tiling, you must use a level or aluminum alloy as a ruler.

Tips 5. Prevent empty drums. Check that the empty drums cannot be knocked as soon as the tiles are pasted. It is best to wait two or three hours before knocking, paying particular attention to the four corners of the tiles. I suggest that everyone should be knocked piece by piece. When you hear the empty drum, you must rework it. Don’t be soft-hearted, because at this time, if you make do, you will know the danger of empty drum when you finally install something on the tiles. If you drop a corner when you hit the tile, you will cry without tears.

Title 6: The floor of the bathroom must be sloped towards the floor drain, and the slope should be increased appropriately. The original drainage and sewage pipes and the location of the floor drain should be avoided as much as possible when the plumbing in the bathroom is decorated to avoid damage to the waterproof layer due to repipes and chiseling the floor. Cause leakage.

Tip 7: If you use toner to match the color of tile jointing agent, you'd better adjust it first, and then decide the dosage, otherwise it is either too light or too dark.

Tip 8: The slope of the bathroom decoration floor should be considered before laying bricks. The slope according to the national standard cannot achieve the effect of rapid drainage, and if you use a deodorant floor drain or an ultra-thin floor drain, it will greatly aggravate the difficulty of drainage .

Tip 9: Do not spread ordinary tiles just because the laundry room is not very important, it must be done well. Inexpensive ceramic tiles are easy to absorb water, and there will be color differences.