Types of hardware shrapnel molds

The metal shrapnel mold uses a high-speed punch in the stamping process, which is high risk. If the operation is improper, the mold can cause serious damage and will harm the safety of the operator. The hardware shrapnel will be the lower machine. The following operations must be performed to ensure the safety of the mold and the operator. The metal shrapnel mold machine is under normal and abnormal shutdown in the following two situations. Normal machine under one or five gold dome molds: 1. First hit the punch and slowly drop it on the counter, switch to the bottom dead center punch (180 °), and cut the tape; no mold is not cut when the belt is dead, which will easily cause plastic deformation and mold damage. 3. Unscrew the upper and lower mold screws 4. To the top of the dead center, the punch and the mold die to a center position, two people die at the same time, no one died to ensure safety. 5. The mold car must be a certain distance from the press before they can lower the height of the car. Prevent mold auto news platform from causing mold slides. 6. Clamping screws, scissors, hooks, and flashlight modes are strictly prohibited when they are placed on the operating platform of the die press. Metal shrapnel moldTwo machine, metal shrapnel molds in exceptional cases: 1. Turn off the main power and counter, 2. After the flywheel, a full stop or paper made of plastic is placed on the diagonal around the mold to show here. It does not pad between the discharge plate and the mold plate, nor does it use iron instead of plastic to inject the mold. 3. The safety bar shakes the flywheel (do not use the hand-painted flywheel safety rod for stopping without stopping or running the flywheel) Protest here 4. Unscrew the upper and lower mold screws, pull the flywheel to 0 ° ~ 70 ° by the safety bar, you can put down the mode.