Uses and characteristics of drawing presses for stamping parts processing equipment

The stamping part processing equipment includes a drawing press, which is mainly used to deepen the sheet into various cylindrical parts, box-shaped parts and complex hollow parts such as automobile cover parts, or used to further change the shape of the stamping part Forming; the characteristics of the drawing press of stamping parts processing equipment are: 1. The drawing press has an edge holding device 2. The press slider maintains a low and uniform working speed when the stamping parts are processed and deep; 3 , The drawing press has a large working energy, among which the drawing press of stamping parts processing equipment includes a single-action drawing press, a double-action drawing press, and a three-action drawing press; 1. a single-action drawing press It is characterized by simple structure, relatively low price and good performance; 2. The double-action drawing press is mainly used for deep drawing of complex stamping parts. It has two sliders, an inner slider and an outer slider. The outer sliding block is used for blanking, also called blanking block. The inner sliding block is used for deep drawing, also called deep drawing block. The outer slide block reciprocates in the guide rail of the fuselage, and the inner slide block reciprocates in the guide rail of the outer slide block; 3. There are 3 slide blocks in the three-action deep drawing press, and the upper part of the press has a deep drawing slide and A blanking slider, they share a drive system, the structure is similar to a double-action deep drawing press, there is a deep drawing slider at the bottom of the press, which is controlled by another drive system, if you don’t use this slider, just disengage it. It has become a double-action deep drawing press; article recommendation: The influence of the stiffness of the press on the metal stamping parts Previous post: How can automotive stamping parts processing manufacturers improve product productivity?