What are the common problems in the production of stamping parts in Dongguan Precision Stamping Parts Factory?

Due to the continuous upgrading of the stamping industry, the technology is upgraded very quickly. The use of precision stamping parts continuous mold production is a relatively efficient and energy-saving production method. Precision stamping parts are usually high-precision and large-volume products, and precision stamping parts continuous molds are used. Production is very convenient, but no matter how efficient the mold brings, it will also have undesirable problems. Today, Dongguan Precision Stamping Factory will take everyone to popularize professional knowledge. Common common problems in the production process of precision stamping molds usually include: 1. Spring loss of precision stamping molds: continuous mold springs are easy to damage, which is usually a problem that is easily overlooked during the production process. The problem is small, but it is The problem is not small, different precision stamping products require different strengths of the mold, so the continuous mold spring also needs to require the operator to perform regular maintenance and replacement for it. We have also seen many peers basically do not carry out the mold Maintenance and maintenance, and even no exchange talks again, when the mold is damaged or the size offset is checked, the cause is not found, and it can be solved after replacing the old spring; so, for different Products, different equipment and molds use different springs. If regular maintenance is not carried out, it is easy to damage the mold itself and cause unnecessary losses. This is a typical example of small losses. 2. The problem of rapid wear of the punch of the precision stamping die and rapid wear of the punch is usually caused by: 1. The mold gap is small; 2. The center of the punch and the mold is poor, and the mold guide assembly and the mold base are not accurate enough. The forming die is not discharged smoothly; 3. After long-term uninterrupted production of the punch, the punching needle of the die is overheated, resulting in excessive temperature of the punch and accelerated wear; 4. The precision of the machine tool for producing the mold is not high, causing the punching needle to deviate The upper mold causes damage to the male and female molds; 5. The continuous mold sharpening method is inaccurate, which causes the mold to anneal and wear faster. Third, the neutral problem of precision stamping parts molds usually has the following problems: 1. The design and accuracy of the mold cannot meet the requirements; 2. The accuracy of the guide sleeve of the mold punch is not enough; 3. The gap of the mold design is unreasonable; 4. Die wear after long-term use leads to poor neutrality; 5. Poor neutrality of the upper and lower turntable mold mounting seat of the machine tool The common problems in the production of stamping parts discussed by Dongguan Precision Stamping Parts Factory are here. [Precision] is a precision stamping exclusive customization company with 15 years of ingenuity integrating Ru0026D, production, sales and service. With more than 20 years of experience in Ru0026D engineering and mold masters, the qualified rate of accurate mold opening for customers is extremely high, which effectively saves customers time and cost. contact details: