What are the factors that cause the bending of metal stamping parts-hardware

What factors will cause the size and shape of the metal stamping parts to be unqualified when it is bent? [Hardware] 1. The springback of the metal stamping parts causes the product to be unqualified. 2. The metal stamping parts locator is worn out and deformed, which makes the strip positioning inaccurate, and a new locator must be replaced. 3. When the metal stamping parts are adjusted on the press in a non-guided bending die, the lower dead center position of the press slider is not adjusted properly, which will also cause the shape and size of the bent parts to be unqualified. 4. The pressing device of the metal stamping die is out of order or has no effect at all. The pressing force must be re-adjusted or the pressure spring must be replaced to make it work normally. The author's introduction above hopes to be helpful to you. Good reputation comes from good quality, and good quality comes from people's meticulous craftsmanship of metal stamping parts. If you need to know about stamping, please call us quickly: